Faulty Signal

Faulty signal

Checking the connectors and cables








- Ignition off
- Check the connector between the differential electronic module (DEM) and the temperature sensor. Check for contact resistance and oxidation.

Hint: Read off the temperature sensor signal to check the function.

Remedy as necessary.

Other information:
- Signal specification, differential electronic module (DEM) , M58, AW50/51 AWD Pinout Values and Diagnostic Parameters
- Temperature / pressure sensor active on demand coupling, replacing, M58, M66 AWD, AW50/51 AWD Temperature / Pressure Sensor Active On Demand Coupling, Replacing
- Checking wiring and terminals Checking Wiring And Terminals










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the temperature.
Check that the value is within its permitted range. Compare it to the ambient temperature.





Is the temperature reading OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the connectors and cables

-------------------------------------------------