Turn Signal Bulb: Service and Repair

Bulbs

Bulb tail lamp/stop lamp/back-up lamp/rear fog lamp/turn signal lamp, replacing

NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Switch resetting







Ignition off.
Reset the lighting switch.

Location of components







NOTE: There is only a fog tail lamp bulb in one of the tail lamps. In the left tail lamp on left-hand drive vehicles or in the right tail lamp on right-hand drive vehicles.

Method content

This method consists of:

- Bulb tail lamp/stop lamp/back-up lamp/rear fog lamp/turn signal lamp, replacing:Bulb for turn signal lamp/stop lamp, replacing
- Bulb tail lamp/stop lamp/back-up lamp/rear fog lamp/turn signal lamp, replacing:Bulb for tail lamp/fog tail lamp/back-up lamp/turn signal lamp, replacing

Bulb for turn signal lamp/stop lamp, replacing

Removing the loudspeaker

Remove the loudspeaker D-post.

Removing the bulb for turn signal lamps

Remove:







- the bulb holder and bulb
- the bulb.

Installing the bulb for turn signal lamps

Install:
- the bulb
- the bulb holder and bulb.

Removing the bulb for stop lamps

Remove:







- the connector
- the bulb holder and bulb
- the bulb.

Installing the bulb for stop lamps

Install:
- the bulb
- the bulb holder and bulb
- the connector.

Installing the loudspeaker

Install the D-post loudspeaker.

Bulb for tail lamp/fog tail lamp/back-up lamp/turn signal lamp, replacing

Removing the side panel

Remove the cover in the side panel.

Removing the bulb for tail lamp/fog tail lamp/back-up lamp

Remove:







- the bulb holder and bulb
- the bulb.

Installing the bulb for tail lamp/fog tail lamp/back-up lamp

Install:
- the bulb
- the bulb holder and bulb.

Installing the side panel

Install the cover in the side panel.
Test the function.

Removing the LED for the side marker lamps

Remove:
- the tail lamp.
- the 2 screws
- the cover.

HINT: Note the routing of the cable.







- the 2 flat pin connectors
- the LED plate.

Installing the LED for the side marker lamps

Install the LED plate.

NOTE: Route the cable through the hole in the lamp housing.

Install:
- the 2 flat pin connectors
- the cover
- the 2 screws
- the tail lamp.

Test the function.