FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Child Seat, Protective Cushion












Child seat, Protective cushion













INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Child seat, Protective cushion




- Take the protective cushion and locate the child seat in its correct position with the protective cushion between the seat's backrest and the dashboard. The lower edge of the protective cushion must be approximately edge to edge with the lower edge of the dashboard.
- Mark out the lower edge of the protective cushion on the end face of the seat with a strip of tape.




- Wash the back of the child seat for affixing the Velcro strap using a mixture of 30% washer fluid and 70% water as indicated by the marking.
- Wipe dry.




- Pull off one Velcro strap from the protective cushion.

Note! Do not pull only on the white protective tape.




- Pull off the protective tape from the detached Velcro strap.
- Press the Velcro strap into the centre of the backrest and according to the tape marking in the lower edge.
- Press the protective cushion into the seat's backrest.
- Remove the tape marking.