Cargo Compartment Safety Grille

Cargo compartment safety grille


















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Cargo compartment safety grille




- Remove the protective caps over the nuts on both sides of the cargo compartment grille
- Slacken off the nuts so that they are at the tips of the screws retaining the grille
- Fold the rear backrests forward.





Installing the cargo compartment safety grille
- Lift the grille into the car through the boot
- Insert the rounded head of the mounting screw (1) into the rear part of the hole in the mounting in the left-hand cantrail. Slide the mounting for the grille forward so that the screw is at the front edge of the cantrail mounting. Check that the screw is locked in the mounting and does not turn.

Note! Do not damage the headlining.

- Position the locating pin (2) in the mounting for the grille. It must be in the rounded section of the cantrail mounting. Tighten the nut a little
- Repeat on the right-hand side, but first press the grille towards the left-hand mounting in the cantrail so that the sprung mounting in the grille springs in, allowing the right-hand mounting to be positioned
- Check that the grille is correctly positioned in both mountings in the cantrails. Tighten the nuts. Tighten to 11 Nm (9 lbf. ft.).




- Install the protective caps on the nuts
- Fold the grille up towards the roof. There are gas struts so a little force is required. Return the backrests to the upright position before folding the grille down again.

Removing the cargo compartment safety grille
The grille must be down for removal. Fold the rear backrests forwards to relieve the load on the gas struts. Then detach the grille. See points 1 and 2.