Sealing Ring, Bevel Gear, Left

Sealing ring, bevel gear, left

Operation number: 43335-2

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Removing bevel gear
Remove the bevel gear. Refer to: Bevel gear, B8444S, TF-80SC AWD Bevel Gear




999 7086 Puller 999 7086 Puller

Note! Check thoroughly that no seal residue remains.




Position the bevel gear over a receptacle.
Allow the oil to run out through the bearing.
Clean any spilled oil from the seal ring seat in the bevel gear using a lint-free cloth.

Installation





Install:
- 999 7189 Drift 999 7189 Drift
- the gasket




999 7189 Drift 999 7189 Drift

Note! When the tool is removed, check that 999 7189 Drift was removed with it.

Installing the bevel gear
Install the bevel gear. Refer to: Bevel gear, B8444S, TF-80SC AWD Bevel Gear

Finishing

Checking the oil level




Check the oil level in the bevel gear.
Use oil. Refer to: Lubrication transmission Specifications
Fill up oil to the oil filler plug. Suck out 0.1 l oil.
Torque: Oil filler plug, bevel gear, 35 Nm