Fault-Tracing

Fault-tracing

Checking components and wiring




- Ignition off
Check the engine for heavy oil leakage.
Check the level of the engine oil.
Check the oil level sensor connector and terminals. Check for contact resistance and oxidation.
Remedy as necessary.

Other information
- Level sensor engine oil, B8444S Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, components, etc.
- Start the engine.
- Read the diagnostic status and fault status for the diagnostic trouble code by selecting the diagnostic trouble code in the list.
Increase the engine speed a few times until the scan is "Implemented".
Check the fault status for the diagnostic trouble code when the scan is "Implemented". When the function is correct the fault status should be "No fault found" when the scan is implemented.





Is the function OK?

Yes - Troubleshooting complete for this DTC

No - Fault-tracing information

-------------------------------------------------