Fault-Tracing

Fault-tracing

Replacing thermostat

Note! This diagnostic trouble code (DTC) is stored if the engine temperature sensor freezes. This may happen if the coolant level is low or there is too little glycol in the coolant. Check the coolant level and its freezing point.

Engine control module (ECM) has registered that the actual temperature increase has deviated from the calculated temperature increase. This deviation is probably due to a damaged thermostat.
Check cables and connectors between engine control module (ECM) and engine temperature sensor for contact resistance and oxidation.
Remedy as necessary.

Other information
- Signal specification, B8444S Signal Specification, Engine Control Module (ECM)
- Thermostat, B8444S Service and Repair
- Engine coolant temperature sensor (ECT), B8444S Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Replacing thermostat

-------------------------------------------------