Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition




The lock-up solenoid SLC1 controls the lock-up function in the gearbox. The SLC1 solenoid works when it receives power from the transmission control module (TCM) and depending on the speed, accelerator position and driving program setting, the solenoid will be activated for different driving conditions.
If the transmission control module (TCM) registers that the measured current in the solenoid circuit is incorrect, the diagnostic trouble code (DTC) is generated. The SLC1 solenoid is then not able to regulate the system pressure.
The diagnostic trouble codes (DTCs) can be diagnosed during shifting when the line pressure solenoid SLC1 is activated.

Substitute value
- Auxiliary program Emergency mode 1 in the transmission control module (TCM) has started.

Hint: Emergency mode in case of malfunction Emergency Mode In Case of Malfunction

Possible source
- Contact resistance in the terminals
- Open circuit in lead for control signal or signal ground.
- Linear pressure solenoid SLC1 stuck.
- Linear pressure solenoid SLC1 not working.

Fault symptom[s]
- General warning lamp lit
- Malfunction indicator lamp (MIL) lit.
- Harsh gear changing
- No gear changing.
- Abnormally slipping gears.