Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition




The transmission control module (TCM) continuously monitors the voltage and compares it with a voltage value sent out on the CAN network by the central electronic module (CEM).
If transmission control module (TCM) registers that the power supply to the control unit is below approximately 10.2V or above 15.5V, the diagnostic trouble code (DTC) will be generated.
The diagnostic trouble code (DTC) can be diagnosed while the engine is running.

Substitute value
- Auxiliary program Emergency mode 1 in the transmission control module (TCM) has started.

Hint: Emergency mode in case of malfunction Emergency Mode In Case of Malfunction

Possible source
- Battery voltage too low.
- Contact resistance or oxidation in the connector on the transmission control model (TCM) or the gearbox.
- Battery charger with incorrect voltage has been used.
- Internal fault in transmission control module (TCM).

Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
- General warning lamp lit