Tire Pressure Sensor: Service and Repair

Tire pressure sensor, replacement

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Remove:
- the wheel
- the tire from the rim.

Caution! Do not use tools within the marked area.

Caution! Always start outside the marked area and continue in the direction from the valve.

Caution! Release the tire bead from the wheel rim diagonally opposite to the valve.

Removal

Removing the sensor





Remove:
- the nut
- the sensor.

Installation

Note! For tightening torques, see: Tightening torque [1][2]Specifications.

Installing the sensor





Note! Always use new gaskets when replacing tires.

Install:
- the sensor
- the nut. Tighten. See: Tightening torque [1][2]Specifications.

Finishing





Caution! Do not use tools within the marked area.

Caution! Always start outside the marked area and continue in the direction from the valve.

Fit the tire and balance the wheel.

Install the wheel. See: Installing wheels Service and Repair.

After replacing sensors, the control module does not need programming. The control module contacts the sensor itself after a few minutes driving. LF initiator can be used.