Fuel Pressure Sensor: Service and Repair

Fuel pressure sensor

Operation number: 28406-3

Note! Some variation in the illustrations may occur, but the essential information is always correct.






Removal

Note! Removal steps in this procedure may contain installation details.

Work on the fuel system. Refer to: Safety regulations for handling fuel Safety Regulations for Handling Fuel

Depressurize the fuel system. Refer to: Fuel system pressure release Service and Repair

Warning! Wear protective goggles.




Blow clean with compressed air around the fuel pressure sensor.

Remove the following items:
- cable tie
- Connector
- screw.




Place paper under the fuel pressure sensor to take care of any petrol that may remain in the fuel distribution pipe.
Cut out the bottom of a plastic bottle and place on the paper.
Remove the fuel pressure sensor.

Installation




Lubricate the O-ring on the new fuel pressure sensor.
Use: Lubricant, 1161580

Install the following items:
- the fuel pressure sensor
- screwTorque: M5, 5 Nm

- cable tie
- the connector
- cable in the cable tie.

Start the engine and check that there are no leaks.