Connecting The Breakout Box

Connecting The Breakout Box

Special tools:
951 1428
951 1499
951 1507
981 3194

Connecting the breakout box

- Ignition off.
- Remove the door panel
- Disconnect the module connectors.

NOTE: Unplug the 12 pin connector before the 30 pin connector.

Connect the adapter to the control module's connector. Connect breakout box 951 1428 and cable harness 951 1499 to the adapter.
Adapter cable harness 951 1507 is for the 12 pin connector, and adapter cable harness 981 3194 is for the 30 pin connector.

Disconnection of breakout box in reverse order.

Other information
- To remove the door panel, see Replacing the front door side panel
- For further information about signals and other values, see Signal specification.