Checking the Road Traffic Information (RTI) Control Module

Checking the road traffic information (RTI) control module

Fault-tracing information
Before continuing with fault-tracing, the following must be checked:
- All tests for the relevant symptom must have been carried out
- No component, connector or wiring faults etc. should have been detected.

Have all tests been carried out and no faults detected?

Yes - Replacing the component

No - No Fault Found

-------------------------------------------------

Replacing the component
Try a new road traffic information (RTI) control module.

Caution! A new RTI control module is delivered without software. The RTI control module must be programmed in order to function after replacement.

Other information:
- To program and access and replace the RTI control module, see Road traffic information module (RTI), replacing Service and Repair.

Hint: Tell the customer that it may take 15 minutes of driving before the system is calibrated and functioning satisfactorily.

Was a fault detected?

Yes - Fault Found

No - No Fault Found

-------------------------------------------------