Installing the Breakout Box, Power Seat Module (PSM)

Installing the breakout box, power seat module (PSM)

Special tools:
951 1463 Adapter 22-16-14 pin 951 1463 Adapter 22-16-14 Pin
951 1428 Breakout box 951 1428 Breakout Box
951 1499 Cable 951 1499 Cable
981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428

Connecting the breakout box




- Ignition off
- Remove the fuse
- Remove the side panel
- Disconnect the control module connector.
Connect adapter 951 1463 Adapter 22-16-14 pin 951 1463 Adapter 22-16-14 Pin to the control module connector. Connect breakout box 951 1428 Breakout box 951 1428 Breakout Box and wiring 951 1499 Cable 951 1499 Cable to the adapter.
Alternatively, breakout box 981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 can be connected to the adapter.
Disconnect the breakout box in reverse order.

Other information:
- For left-hand drive cars, see Signal specification, L.H.D Signal Description, Power Seat Module (PSM)
- For right-hand drive cars, see Signal specification, R.H.D Signal Description, Power Seat Module (PSM)
- Control module front seat Service and Repair Control module front seat Service and Repair
- For information about the fuses, see the relevant wiring diagram.