Connector Control Module Extra Safety System

Cables

Connector control module extra safety system

Special tools:
951 2812
951 2637

NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Disassembly

Disassembling secondary lock





Press in the active catches on both sides of the socket housing and slide out the receptacle housings.

CAUTION: Disconnect and work with only one cable at a time to minimize the risk of mixing them up.

Disassembling primary lock





Press in the locking tab on the cable terminal and carefully pull out the cable and the cable terminal. Use tool: 951 2812 or tool: 951 2637.

Assembly

Assembling primary lock
Check that the cable terminal is undamaged.

Press the cable terminal into the housing.

Check that the cable terminal is properly locked by pulling carefully on the cable.

Assembling secondary lock
Press the secondary lock into place.