Clutch Switch: Service and Repair

Position sensor clutch pedal engine compartment

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Removing the battery





Remove:
- the battery negative lead.
- the battery
- the box for the battery.

Removal

Removing pedal position sensor




Disconnect the connectors.




Remove the pedal position sensor.

Installation

Installing pedal position sensor




Install the pedal position sensor.

Hint: Connect the connector in the sensor using the cable. First align the rear end of the sensor opposite the cowl panel. Then position the sensor straight and press into place.




Install the connectors.

Finishing

Installing the battery





Install:
- the box for the battery
- the battery
- the battery negative lead.