Bracket Lower Torque Rod

Bracket lower torque rod

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Remove the splashguard under the engine (if applicable).

Removal

Removing the torque rod bracket





Remove:
- the screw (1)
- the 3 x screws (2)
- the torque rod bracket.

Installation

Installing the torque rod bracket

Note! For tightening torques, see Specifications. Tightening Torque.





Install:
- the bracket for the torque rod
- the 3 x M10 screws (2)
- the M12 screw (1).

Finishing

Install the splash guard under the engine (if applicable).