Faulty function

Faulty function

Checking the component








- Switch off the ignition. Wait 10 seconds
- Set the switch to the ON position
- Switch on the ignition. Wait 10 seconds.
Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.

If the diagnostic trouble code (DTC) is intermittent:
SelectContinueto erase the diagnostic trouble code (DTC).

If the diagnostic trouble code (DTC) is permanent, continue fault-tracing according to:
Check the connectors for:
The switch and the Supplemental restraint system module (SRS). Check the pins and terminals. Check for contact resistance and oxidation. Check for damage.
Check the cable between the supplemental restraint system module (SRS) and the switch connector. Check for an open-circuit or short-circuit.
Check the cable between:
- The Supplemental restraint system module (SRS) terminal #B12 and switch connector terminal #1.
- The Supplemental restraint system module (SRS) terminal #B27 and switch connector terminal #2.
- The Supplemental restraint system module (SRS) terminal #B8 and switch connector terminal #5.
Remedy as necessary.
If no fault is found, replace the switch for the passenger airbag.

Other information
- Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification Signal Specification
- For further information, see the wiring diagram.
- To access or replace the switch for the airbag and the connectors, see:
- Air bag supplemental restraint system Service and Repair Air bag supplemental restraint system Service and Repair
- Wiring harness supplemental restraint system (SRS) Wiring Harness Supplemental Restraint System (SRS)
- Checking wiring and terminals Checking Wiring and Terminals





Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Switch off the ignition. Wait 10 seconds
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead. Wait 10 seconds.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component

-------------------------------------------------