Shorted

Shorted

Checking the component and wiring








- Switch off the ignition. Wait 10 seconds
- Disconnect the connectors from the supplemental restraint system module (SRS).

Caution! Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).

Check the connector. Check for a short-circuit between the terminals:
- #A63 and #A64.
Check the cables between the control module and the seat belt buckle. Check for a short-circuit.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification Signal Specification
- For further information about cable routing and terminals, see the wiring diagram
- Front safety belt buckle Front Safety Belt Buckle
- Air bag supplemental restraint system Service and Repair Air bag supplemental restraint system Service and Repair
- Wiring harness supplemental restraint system (SRS) Wiring Harness Supplemental Restraint System (SRS)
- Checking wiring and terminals Checking Wiring and Terminals

Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Switch off the ignition. Wait 10 seconds
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead. Wait 10 seconds.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------