Configuration Fault

Configuration fault

Checking the component








- Switch off the ignition. Wait 10 seconds
- Disconnect the connector from the roll-over bar cassette.
- Disconnect the connectors from the supplemental restraint system module (SRS).

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical airbag. This could deploy the airbag!

Caution! Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).

Check the connectors for the roll-over bar cassette and the supplemental restraint system module (SRS). Check for damaged pins and terminals. Also check the wiring.
Remedy as necessary.
Check that the correct supplemental restraint system module (SRS) is installed in the car.
- Disconnect the connector for the roll-over bar cassette.
- Connect the connectors for the supplemental restraint system module (SRS)
- Switch on the ignition. Wait 10 seconds
- Read off by clicking the VCT2000 symbol.
If no fault is found, replace the control module.

Other information
- Signal specification Signal Specification, Supplemental Restraint System Module (SRS)
- For further information about cable routing and terminals, see the wiring diagram
- Air bag supplemental restraint system Service and Repair Air bag supplemental restraint system Service and Repair
- Safety cassette (ROPS) Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals





Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Switch off the ignition. Wait 10 seconds
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead. Wait 10 seconds.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component

-------------------------------------------------