Fault-Tracing
Fault-tracing
Checking the diagnostic trouble codes (DTCs)
Check whether the diagnostic codes for clutch pedal sensor (9110, 911B, 911C or 911D) are stored in the engine control module (ECM).
If the diagnostic trouble code is stored, it indicates a fault in the clutch pedal sensor. This, in turn, could cause generation of the diagnostic trouble code. If so, perform all troubleshooting acc. to these diagnostic trouble codes first.
Do you want to continue with the procedure?
Yes - wiring and connectors
No - No Fault Found
-------------------------------------------------
Checking the component, wiring and connectors
Check the clutch pedal switch's cable and function by measuring between Engine control module (ECM) #B13 (#C13) and ground (chassis connection).
Remedy as necessary.
Other information:
- Checking wiring and terminals Checking Wiring and Terminals
- Signal specification, B5254T7 Signal Specification, Engine Control Module (ECM)
Continue - Verification
-------------------------------------------------
Verification
Verification
- Turn off the ignition.
- Reinstall the connectors, components etc.
Check whether the fault has been remedied by switching on the ignition and attempting to start the engine. Release the ignition key/start knob from position III as soon as the starter motor has started to crank.
The autostart function should drive the starter motor until the engine starts.
Has the fault been remedied?
Yes - Troubleshooting procedure complete
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the diagnostic trouble codes (DTCs)
-------------------------------------------------