Internal Fault

Internal fault

Replacing the component
The central electronic module (CEM) has detected that the right-hand gas discharge lamp module (GDL) has an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the gas discharge lamp module (GDL) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the fault recurs, replace the right-hand gas discharge lamp module (GDL).
If the fault is permanent, replace the right-hand gas discharge lamp module (GDL).
If the gas discharge lamp module (GDL) is replaced, the position sensor must be calibrated.
Remedy as necessary.

Other information:
- Headlamp ballast (Xenon) Headlamp Ballast (Xenon) Headlamp ballast (Xenon) Headlamp Ballast (Xenon)
- Calibration of position sensor, GDL lamps Testing and Inspection





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Light switch in position 2.
Switch between high and low beam.
Check that the function is OK.

Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

-------------------------------------------------