Signal Too Low

Signal too low

Fault-tracing information
Missing function may be due to a blown fuse.
Check that the fuse for the function in question is intact.
Replace the fuse if it is damaged.

Was a fault detected?

Yes - Verification

No - Checking the wiring

-------------------------------------------------

Checking the wiring








- Ignition off.
Check central electronic module (CEM) connector F and the seat belt buckle connector. Check for contact resistance. Check for oxidation. Check for damage. Check for loose connections. Also check the intermediate connector.
Check the signal cable. Check for an open-circuit. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) terminal #F2 (#2) and right rear seat belt buckle, connector terminal #2.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Signal Description, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Control module relay box passenger compartment Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate reading off the status. Click the VCT2000 symbol.
Activate and deactivate the function.
Check that the function is OK.





Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------