Signal Too Low

Signal too low

Checking the status




- Ignition on.
Check the signal from the clutch pedal sensor.
Click on the VCT2000 symbol to read off the voltage level.
Slowly depress and release the clutch. Note the change in the signal level.
The voltage level in the clutch pedal sensor must be between 0.15 and 4.75 volts.

Hint: If the signal from the clutch pedal sensor indicates less than 0.15 volts, there is either an open-circuit in the cable or the clutch pedal sensor is defective.





Does the value change?

Yes - Verification

No - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
Check the clutch pedal sensor resistance.
Check the signal cable between central electronic module (CEM) terminal #G21 (#21) and clutch pedal sensor connector terminal #3. Check for a short-circuit to ground.
Check the signal cable between central electronic module (CEM) terminal #G23 (#23) and clutch pedal sensor connector terminal #2. Check for a short-circuit to ground.
Check the signal cable between central electronic module (CEM) terminal #G12 (#12) and clutch pedal sensor connector terminal #1. Check for a short-circuit to ground.
Try replacing the clutch pedal sensor if no fault is found in the wiring.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Signal Description, Central Electronic Module (CEM)
- Control module relay box passenger compartment Service and Repair
- Position sensor clutch pedal engine compartment Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the clutch pedal sensor. Click the VCT2000 symbol.
Check that the value is between 0.15 and 4.75 volts.





Is the value OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------