Faulty Signal

Faulty signal

Checking the sensor




- Ignition on.

Checking the components and connectors
Check the connectors. Check for contact resistance. Check for oxidation. Check for loose connections.
Check the sensor in the seat. Take readings between:
- terminals #2 and #3 on connector B for the seat heating module (SHM). Check for an open-circuit
- terminal #2 on connector B and chassis ground. Check for a short-circuit to ground
- terminal #2 on connector B and terminal #4 on connector A. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information:
- For further information about the connectors, fuses and relays, see the relevant section in the Wiring Diagram
- Connecting the breakout box Connecting The Breakout Box, Climate Control Module (CCM)
- Signal specification Signal Description, Climate Control Module (CCM)
- Location of components Component Location, Climate Control Module (CCM)
- Seat Heating Module (SHM) Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the seat heating. Check that the seat heats up.

Is the seat heater functioning?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the sensor

-------------------------------------------------