Non-Approved Value

Non-approved value

Checking data for car configuration




- Ignition on.
The climate control module (CCM) has registered that a parameter in the data for car configuration is incorrect.
Check which parameter is incorrect by clicking on the VCT2000 symbol.
The reason for the parameter being incorrect may be that the climate control module (CCM) has been replaced incorrectly.
Switching the climate control module (CCM) between different cars can result in the data in the car configuration being incorrectly adapted.
If this is the case, remedy by replacing the climate control module (CCM) in the correct way.

Other information:
- Location of components Component Location, Climate Control Module (CCM)
- Climate control module (CCM) Service and Repair





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.





Has the status of the diagnostic trouble code (DTC) changed?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking data for car configuration

-------------------------------------------------