Faulty Signal

Faulty signal

Replacing the body sensor cluster stability sensor (BSC)




The diagnostic trouble code (DTC) indicates that the body sensor cluster stability sensor (BSC) has an internal fault.
Replace the body sensor cluster stability sensor (BSC).

Other information
- Accelerometer and yaw angle sensor Accelerometer and Yaw Angle Sensor





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, components, etc.
- Test drive the car according to: Test Drive Form (DSTC (dynamic stability and traction control) /brake control module), description Test Drive Form (DSTC (Dynamic Stability and Traction Control) /Brake Control Module), Description
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the body sensor cluster stability sensor (BSC)

-------------------------------------------------