Variation 2

Engine cooling fan (FC)

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Remove the expansion tank cap.
Block the 2 coolant hoses using lock grip pliers.
Install a hose on the nipple at the radiator.
Feed the hose down to a container.
Open the nipple and drain off the coolant.

Removal

Removing the oil cooler for automatic transmissions

Note! Applies only to cars with automatic transmissions

Remove the oil cooler. .

Removing the radiator hoses
Remove the 2 radiator hoses.

Removing the engine cooling fan (FC)




Remove the 2 connectors for the engine cooling fan.
Press in the two retaining clips. Lift the engine cooling fan from the catches.
Remove the fan downwards.

Installation

Note! For tightening torques, see: Tightening torque, B5244S4, M56, B5244S4, AW55-50/51SN Tightening Torque.

Installing the engine coolant fan (FC)




Press the fan shroud into the mounting points.

Note! Ensure that the 2 retaining clips secure the fan shroud.

Install the 2 radiator hoses on both sides. Remove the lock grip pliers from the radiator hoses.

Installing the oil cooler for automatic transmissions

Note! Applies only to cars with automatic transmissions.

Install the oil cooler for the automatic transmission. .

Finishing

Fill with coolant and run the engine until the thermostat opens. Top up as necessary.

Note! Automatic cars only. Check the oil level in the transmission. Top up if required.