Procedures

Net pocket, side panel



























INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Net pocket, side panel










- Apply a wide piece of tape to mark the rear hole for the net pocket.





- Press two clips into the rear end of the net pocket. The buttons (1) of the net pocket must be facing outwards.





- Place the rear end of the net pocket against the rear panel as illustrated.
- Make marks through the holes in the clips and on the pieces of tape where the holes are to be. Use a pen.





- Remove the tailgate's sill panel by pulling it up until the four clips on the upper side and the eight catches at the lower edge release.





- Check on the reverse of the panel that there are no cables in the way where the holes are to be made.
- Insert a scriber through the marked holes and press through the panel so that the holes are enlarged to approximately -4.8 mm (3/16"). Counterhold the reverse of the panel if necessary.
- Remove the tape strip.






Note! Do not trap the net in the pop rivet when the clip is secured.










- Press the two clips into the net pocket's front end.





- Position the clips as illustrated.
- Position the net pocket against the side panel.
- Insert a scriber through the holes in the clips and press through the panel so that the holes are enlarged to approximately -4.8 mm (3/16").






Note! Do not trap the net in the pop rivet when the clip is secured.