Not Chassis 190000- [4 of 4]

Note! Ensure that the connector's catch clicks and is securely positioned.

- Connect the pre-routed cable to the vacant connection (middle) on the parking assistance module (PAM).





- Remove the protective film from one side of the double-backed tape.
- Secure the tape on the holder.





- Remove the remaining protective film on the holder.
- Install the centering tool in the holder according to the image.






Note! The holders must be mounted turned against the holes as illustrated. The holders must also be horizontal and in line with the bumper cover.

- Press in the holder on the bumper cover.
- Repeat the steps for the other holders.






Note! On left-hand drive cars, the large gray connector must be on the right-hand side. On right-hand drive cars the large gray connector must be on the left-hand side. (see point 54).

- Connect the cable harness connectors to the sensors.
- Install the sensors in their holders.





- Secure the end of the cable harness at the sensors to the bumper cover using butyl tape.






Note! On left-hand drive cars the large gray connector must be on the right-hand side. On right-hand drive cars it must be on the left-hand side.

- Secure the cable harness to the bumper cover using butyl tape in the locations illustrated.





- Hold the bumper up against the car and connect the connector for the sensor cable to the connector at the car.
- Secure the assembled connector on the member (1). Use a tie strap on each side of the connector.
- Connect the connectors to any foglamps.
- Slide the bumper cover into the correct position





- Guide the lower edge of the bumper cover into the guides.
- Reinstall the bumper cover by repeating points in reverse order.
- Reinstall the engine splash guard.





- Reinstall the side panel.
- Reinstall the clip for the cargo floor support.
- Reinstall the sill trim panel.






Note! There are ten clips on the reverse of the panel that must all engage in the body. Take care when aligning so that the clips do not break. Broken clips must be replaced with new ones.





- Reinstall the side panel, ensure that all clips engage.
- Tighten the panel using existing screws.





- Reinstall the panel with the safety clip and the weatherstrip.





- Reinstall the rear sill trim panel, the 2 guides must be in the corresponding cut-outs in the side panel.
- Reinstall the front sill trim panel.
- Reinstall the backrest. Tighten the screws to 15 Nm (11 lbf.ft.).
- Reinstall the arm rest.
- Reinstall the seat cushion.





- Download software (application) for the accessory's function.