Not Chassis 190000- [1 of 4]

Parking assistance, front















































INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Parking assistance, front










- Clean the sensors. Use: Isopropanol
- Allow to dry.





- Carefully mat the surface down. Use: Glasspaper, grade P1000





- Clean the sensors again.
- Use: Isopropanol
- Allow to dry.
- Avoid contact with the cleaned surfaces.






Caution! Protect the connections' contact surfaces against paint.

- Paint the sensors in the same colour code as the vehicle.
- Use Volvo Touch-up paint. (Only use base coat.)
- Use: Volvo 2-K Varnish. P/N: 31335447

Note! Also read the instructions on the spray can.






Caution! The paint must have dried after the first application.





- Turn the ignition switch to position 0.

Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.





- Raise the car
- Remove the screws and the engine splash guard.





- Lower the car
- Carefully grasp the cover for the high pressure washing for the headlamps and pull until the catches are accessible.





- Press the catch up. Remove the cover. Do not damage the painted surfaces or the washer nozzles.
- Carry out on both sides





- Push in the centre of the five clips (1). Remove the clips.
- Remove the two screws (2)





- Remove the screws for the inner wing.





- Take a weatherstrip tool and pry between the headlamp bumper cover (1)
- Then insert the weatherstrip tool in the cut-out (2) and pull straight out until the hooks (3) release
- Repeat the operation on the other side






Hint: Removal of the bumper is facilitated if carried out by 2 people.

- Pull the ends of the bumper cover straight out so that the release from the wing liner.
- Pull the bumper cover straight out until the hooks under the headlamps release, detach the connectors for the fog lamps and place the bumper cover on a surface that will not damage the paint.





- Locate the 4 markings on the inside of the bumper cover.
- Mark the center with a scribe.





- Drill holes in the centers of the markings using a - 3 mm (7/64) diameter drill bit.
- Drill out the holes. Use a -10 mm (25/64") diameter drill bit.





- Enlarge the holes in the bumper cover using hole tool P/N 9997234. Place the hole tool's support sleeve on the inside, and the cutting component on the outside of the bumper cover.





- Clean the inside of the bumper cover using a mild soap solution.
- Clean around the holes and the markings using isopropanol.
- Allow to dry.
- Apply a thin layer of activator, part no. 8637 076, to the cleaned surfaces and let dry for approx. 10 min.





- Take the 4 holders from the kit.
- Clean the surfaces as illustrated. Use: Isopropanol
- Allow to dry.
- Apply a thin layer and even layer of activator. art.no. 8637076.