Handsfree, Microphone, Swan Neck [2 of 4]

- Connect the connectors to the radio/AC unit.
- Reinstall the radio/AC unit by first hooking it on at the upper edge. Then press it upwards and angle in the lower part. At the same time, check that the cable to the control panel for Bluetooth ends up in the right position.
- If the radio/A/C unit does not fit at the rear edge, check that no cables have been trapped.
- Reinstall the screws.
- Reinstall the side panel.
- Turn the ignition key to position II.
- Reconnect the battery negative lead

Applies to S60, V70 and S80 (-06)





- Turn the ignition switch to position 0.

Note! Wait at least three minutes before unplugging the connectors or removing other electrical equipment.





- Turn the clip (1) a quarter turn anti-clockwise.
- Pull the panel out by the rear edge (2).
- Then pull the panel backwards until the hooks release (3).
Remove the panel.
- Repeat the operation on the other side.





- Remove the screws and sound proofing bracket.






Applies to the S60 and V70
- Open the glovebox.
- Lift the two catches past the lugs.






Applies to the S60 and V70
- Unhook the damping.


Applies to the S60 and V70





Remove:
- the eight screws
- the connector for the glove box lighting
- the connector for the legroom lighting
- the glove box.






Applies to the S80 (-06)
- Open the glovebox.
- Lift the two catches past the lugs.
- Detach the gas struts by pulling straight out.


Applies to the S80 (-06)





Remove:
- the ten screws
- the connector for the glove box lighting
- the glove box.

Applies to S60, V70 and S80 (-06)





- Find the headrest's two locks on the back of the driver's seat. Press in the catches and pull the headrest upwards at the same time.





- Find the grip strip (consists of two different strip profiles that are hooked into each other) in the bottom edge on the upholstery.





- Get a weatherstrip tool and pry apart the strips so that the catch (1) releases.
- Pull out the rear part of the upholstery with strip (2).





- Insert a curtain wire or similar from above and down on the back of the seat back, between the upholstery and padding.





- Tape the connector from the microphone cable to the end of the wire.
- Pull through the cable.
- Disconnect the cable from the wire.





- Place the microphone's bracket over the hole on the backrest.
- Point the microphone arm 45° forward. Press down the headrest so that it locks into place.
- Check that the headrest has locked into place by pulling it upwards.





- Route the cable in front of the tube (1).
- Secure the cable with a cable tie to the large connector (2).
- Reinstall the upholstery for the backrest.





- Lay the cable in the carpet joint. Route the cable forward and across in the centre console.

Note! It is important that the cable has the right length so that the seat can move back and forth freely.





- Route the cable on the left side of the opening for the glove box.
- Find the foam tape with connections for the Bluetooth system. Cut the cable tie and open the foam tape.