Handsfree, Bluetooth [2 of 4]

Applies to cars with internal amplifier
- Remove cable harness A from the kit.

Applies to cars with external amplifier
- Remove cable harness B from the kit.

Applies to all models
- Connect the gray connector (2) in the new cable harness to the gray connector (3) which was detached from the media player.
- Take a 700 mm piece of foam tape and cut into three pieces of the same length. Tape one piece around connectors (2) and (3). Position these to the left, in the opening so that they are not in the way when installing the media player.
- Connect the gray connector (1) in the new cable harness to the corresponding socket in the media player.
- Route the cable harness with the connectors down on the right-hand side in the center console.
- Plug the remaining connectors which where detached into the media player.
- Reinstall the media player and secure it.

Installing the control panel





- Clean the area on the centre console as illustrated, which corresponds to the size of the double-sided adhesive tape. Use a solution of 25% isopropanol and 75% water, as well as a lint free cloth. Wipe dry carefully, do not rub.
- Allow to dry

Note! In cases where the area is heavily soiled or treated with cockpit shine, first clean using a washing up detergent.


Illustrations A and B




- Place the control panel cable in the groove as illustrated.









- Remove the protective film from the tape and press the control panel edge to edge against the climate panel and according to the dimensions in the image.





- Press the cable securely into the compartment that is in the joint between the front and rear side of the center console. Stop level with the lower edge of the display opening.
- Reinstall the center console, connect the green connector and install the screws.

Applies to cars with manual gearbox
- Install the gear selector boot in the center console starting at the rear edge.





- Pull the 2 cables down on the right-hand side of the center console.

Installing the microphone





- Unhook the sun visor from the mounting.
Carry out on both sides.





- Remove the lock plug and the mounting.
Carry out on both sides.





- Pull off the driver's weather strip at the A-post and dashboard.
- Pull off the panel from the A-pillar. The panel is secured by three clips.
- Unhook the safety clip.
- Lift the panel upwards and inwards in the vehicle.
- Remove the panel.





- Remove the interior lighting by grasping the front edge and pulling downwards. It is held in place with six catches.





- Remove the three screws.





- Take two 700 mm pieces of foam tape from the kit.
- Cut one piece of foam tape in the middle.
- Tape one long and one short piece of foam tape on the microphone cable starting 70 mm from the microphone.





- Pull down the headlining with the interior lighting frame slightly.
- Route the microphone cable along the top of the existing cable harness as illustrated.





- Route the microphone cable to the front edge of the headlining as illustrated.

Note! Position the cable so that it is not pinched when the sun visor mounting is refitted.





- Make a mark on the foam tape affixed to the cable 230 mm from the microphone.
- Use a cable tie to fasten the cable at the mark at the existing connector.
- Install the three trim screws.





- Hold the microphone cable straight forward and refit the interior lighting.





- Clean the microphone and ceiling panel as illustrated, using isopropanol.
- Remove the backing tape from one side of the Velcro strip and press it onto the microphone.





- Remove the remaining backing tape from the Velcro strip and press the microphone securely onto the ceiling panel as illustrated.

Note! Direct the microphone towards the driver.

Feed in any cable excess.