Faulty Position

Faulty position

Checking the component and wiring




- Ignition off
- Light switch in position 0
- Disconnect connector A from the left-hand gas discharge lamp module (GDL).
Check the connectors for contact resistance and oxidation. Check for damage carefully.
Remedy as necessary.

Other information:
- Connecting the breakout box Connecting The Breakout Box, Central Electronic Module (CEM)
- Location of components Locations
- Checking wiring and terminals Checking Wiring And Terminals

Was a fault detected?

Yes - Verification

No - Checking the component

-------------------------------------------------

Checking the component
Check that the left-hand gas discharge lamp module (GDL) has not been installed on the right-hand side.
If a new gas discharge lamp module (GDL) has been installed, the vehicle information must be programmed and the position sensor must be calibrated.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Central Electronic Module (CEM)
- Location of components Locations
- Checking wiring and terminals Checking Wiring And Terminals





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Light switch in position 2.
Switch between high and low beam.
Check that the function is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the component and wiring

-------------------------------------------------