Sealing Ring, Crown Wheel Shaft, Left-Hand Side, Replace

Sealing ring, crown wheel shaft, left-hand side, replace

Special tools:
999 7086 Puller 999 7086 Puller
999 7189 Drift 999 7189 Drift

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing bevel gear
Remove the bevel gear according to: Bevel gear, replacing Bevel Gear Bevel gear, replacing, TF-80SC AWD Bevel Gear.




Use: 999 7086 Puller 999 7086 Puller.

Note! Thoroughly check that no seal residue remains.




Position the bevel gear over a receptacle.
Allow the oil to run out through the bearing.
Clean any spilled oil from the seal ring seat in the bevel gear using a lint-free cloth.

Installation





Install:
- 999 7189 Drift 999 7189 Drift
- the gasket.




Use: 999 7189 Drift 999 7189 Drift.

Note! When the tool is removed, check that 999 7189 Drift 999 7189 Drift was removed with it.

Installing the bevel gear
Fit the bevel gear according to: Bevel gear, replacing Bevel Gear Bevel gear, replacing, TF-80SC AWD Bevel Gear

Finishing

Checking the oil level




Check the oil level in the bevel gear.
Lubricate. See: Bleed Valve Bevel Gear, Replacing