Anti-Roll Bar Link Rear, Replacing

Anti-roll bar link rear, replacing

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removing the anti-roll bar link





Remove:
- the wheel
- the anti-roll bar link from the mountings. Use a Torx wrench as a counterhold so that the boot is not damaged.

Installing the anti-roll bar link
Install the anti-roll bar link.
Use new nuts. Tighten the nuts. Tighten to 80 Nm.
Use a Torx wrench as a counterhold so that the boot is not damaged.
Install the wheel. See Installing wheels Service and Repair.