Torque Rod Lower, Replacing

Torque rod lower, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparation




Raise the car.
Remove the splash guard under the engine.

Removing the lower torque rod





Remove:
- the screws (A)
- the nuts (B)
- the engine stabilizer brace.

Installing the lower torque rod




Install the strut.

Tighten:
- the screws (A) to the transmission. (M10)
- the nuts (B) against the sub-frame.
- the engine stabilizer brace.

Finishing




Install the splashguard under the engine.