Part 2

Remote start, electric engine block heater

Installing the receiver unit




- Remove the Velcro from the kit and cut it in the centre.




- Press the Velcro pieces together.




- Clean the flat surface of the receiver unit using isopropanol P/N 1161721. Wipe dry.




- Remove the protective backing tape from one of the Velcro pieces.




- Press the Velcro onto the receiver unit.




- Remove the protective backing tape from the other Velcro piece.




- Move the floor and insulating mat out of the way.
- Scrape away any sealant from the flat surface at the lower edge of the A-post where the receiver unit for the remote start is to be located.
- Clean the surface using isopropanol P/N 1161721. Wipe dry.




- Press the receiver unit securely onto the panel surface, 10 mm (25/64") under the cable lead-in for the side door.




- Locate the connector for the blower fan and disconnect the connector.
- Connect the cable from the kit.




- Carefully loosen the secondary catch of the black 6-pin connector using a small screwdriver.




- Connect the red (R) cable from the timer relay to terminal 3, and the black (BK) cable to terminal 6 in the 6-pin connector.
- Press the secondary catch together on the connector.

Synchronizing the Transmitter - Receiver




1. Connect the battery's negative lead.
2. Install batteries in the transmitter battery compartment.
3. Connect the connector and antenna cable to the receiver unit.
4. Within 5 seconds, press the "OFF" button on the transmitter until the LED goes out. Synchronization has been carried out.
- Press the receiver unit onto the Velcro on the body plate if it has loosened.
- Tape up any cable excess from the timer relay and place it next to the receiver unit under the insulation mat.




- Install a new safety clip in the A pillar panel.

Note! It is important to use a new safety clip when installing.

- Press the A-pillar panel into place.

Warning! It is important to install the safety clip/hook and panel correctly so that the IC system is not affected.

Reinstall:
- the dashboard end panel
- insulation and floor carpet.
- the sound proofing.
- Turn the ignition key to position II.