L.H.D.

Heat exchanger, replacing

Special tools:
115 8957 HOSE PLIERS 115 8957 Hose Pliers

The illustrations in this service information are used for different model years and / or models. Some variation may occur. However, the essential information is always correct.

Preparations





Remove:
- the heating loops in the engine compartment. Use special tool115 8957 HOSE PLIERS 115 8957 Hose Pliers (pliers)
- the seal and the plate.

Removing the heat exchanger





Remove:
- the soundproofing panel. See Soundproofing panel, replacing Soundproofing Panel, Replacing
- the screw for the heat exchanger
- the mounting brackets for the pipes.
Position plenty of paper under the heat exchanger and around the pipes.
Drain the coolant into a suitable container.
Detach the pipes and move them out of the way.
Pull out the heat exchanger.

Installing the heat exchanger

Note! Always use new O-rings.

Install the heat exchanger carefully.
Screw the heat exchanger into place.

Install:
- the upper pipe
- the striker plate using round-nosed pliers.

Press in:
- the pipes using a screwdriver
- the catch using a pair of pliers.

Install:
- the lower pipe
- the striker plate using round-nosed pliers.

Press in:
- the pipe using a screwdriver
- the striker plate using round-nosed pliers.

Install:
- the seal and the plate
- the heating loops in the engine compartment.
Start the engine and the heating system.
Fill the cooling system with coolant.
Check that the pipe connectors do not leak.
Install the soundproofing panel. See Soundproofing panel, replacing Soundproofing Panel, Replacing.