Mud Guards, Front

Mudguard front



























INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section.






Mudguard front




- Remove the front wheels
- Carefully drill out the four rivets holding the bumper liner at the rear edge of the front fender. Use a 6 mm (1/4") diameter drill bit
- Remove any rivet swarf.

Note! Do not damage any of the plastic components.




- Install the mudguard. Rivet the mudguard into place in the bumper liner and the rear edge of the bumper cover
- Reinstall the front wheels. Tighten the wheels. Tighten to 140 Nm (103 lbf. ft).