Net Pocket, Cargo Compartment (5 Seat)

Net pocket, cargo compartment (5 seat)
























Net pocket, cargo compartment

Illustration A is for making holes on the left-hand side





Illustration B is for making holes on the right-hand side




- Measure up for drilling holes for securing the net pocket
- Drill out the holes. Use a 3 mm (1/8") diameter drill bit. Use a 10 mm (25/64") drill stop
- Remove the swarf. Smooth out the hole edges if necessary.




- Take two clips, two screws and the net pocket from the kit
- Using the screws and clips, tighten the rear face of the net pocket in the newly drilled holes as illustrated.




- Take two clips from the kit. Install them on the front face of the net pocket in approximately the position shown in the illustration.




- Bend in the front face of the net pocket towards the side panel
- Align the entire front face of the net pocket so that it is parallel with the edges of the panel as illustrated and the lower face so that it is against the floor hatch
- Raise the lower clip so that its lower edge is 50 mm (2") from the floor hatch
- Ensure that the clips are against the panel. Mark the panel for drilling using an awl or scriber through the holes in the clips.




- Angle out the front face of the net pocket
- Drill out the holes. Use a 3 mm (1/8") diameter drill bit. Use a 10 mm (25/64") drill stop
- Remove any swarf.




- Angle the net pocket in towards the panel
- Take two screws from the kit. Tighten the net pocket and clips to the panel as illustrated.