Checking the Auxiliary Input (AUX) Rear Seat Entertainment, Generation 3.2

Checking the auxiliary input (AUX)

Fault-tracing information
If the auxiliary input (AUX) does not function the fault could be due to:
- Wiring or contact resistance in the terminals
- Defective rear seat entertainment module (RSE)
- The AUX-panel
- Externally connected component.









Continue - Checking the auxiliary input (AUX)

-------------------------------------------------

Checking the auxiliary input (AUX)

Checking the settings
Ensure that the problem only occurs when the accessory is connected.
Test by connecting an accessory which definitely functions correctly. For further information about the accessory see the accessory manual.
Check that there is power supplied to the accessory.

Checking the picture signal
Check the wiring for the picture signal. This is the cable between auxiliary input (AUX) terminal #6 and control module terminal #C7. Also check the cable for the picture ground. This is the cable between the auxiliary input (AUX) terminal #5 and control module terminal #C8.

Checking wiring for audio signals
Check the audio wiring for the accessory. The right-hand audio signal. This is the cable between auxiliary input (AUX) terminal #4 and control module terminal #C9.
The left audio signal. This is the cable between auxiliary input (AUX) terminal #3 and control module terminal #C10.
The audio ground lead. This is the cable between auxiliary input (AUX) terminal #2 and control module terminal #C11.

Checking the auxiliary input (AUX)
Check the AUX panel, replace it if necessary. If no other fault is found there could be a fault in the control module.
Remedy as necessary.

Other information
- Signal specification, rear seat entertainment module (RSE) Signal Specification, Rear Seat Entertainment Module (RSE), Generation 3.2
- Rear seat entertainment module (RSE), replacing
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification





Checking the auxiliary jack (AUX)

Checking the auxiliary jack (AUX)
Check that the auxiliary jack (AUX) functions.

Does the auxiliary jack (AUX) function?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------