Configuration Fault

Configuration fault

Checking the component

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical airbag. This could deploy the airbag!

Caution! Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).








- Switch off the ignition. Wait 10 seconds
- Disconnect the connector from driver's airbag stage 3
- Disconnect the contact reel connector
- Disconnect the connector from the supplemental restraint system module (SRS).
Check the connectors to the driver's airbag, the contact reel and the supplemental restraint system module (SRS). Check for damage to pins and terminals. Also check the wiring.
Remedy as necessary.
Check that the correct supplemental restraint system module (SRS) is installed in the car.
- Connect the connector to the driver's airbag
- Connect the contact reel connector
- Connect the connector for the supplemental restraint system module (SRS)
- Switch on the ignition. Wait 10 seconds
- Read off by clicking the VCT2000 symbol.
If no fault is found, replace the control module.

Other information
- Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification Signal Specification
- For further information about cable routing and terminals, see the wiring diagram
- Control module SRS (supplemental restraint system), replacing Service and Repair
- Airbag driver's side (SRS), replacing Airbag Driver's Side (SRS), Replacing
- Disassembling connectors: Igniter wire connector Igniter Wire Connector
- Checking wiring and terminals Checking Wiring and Terminals





Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component

-------------------------------------------------