Description of Parameters

Description of parameters

Parameters, status

Note! The parameters that can be read off are determined by the systems with which the vehicle is equipped.

Engine running
The value indicates if the engine has started.
YES = The engine has started.
NO = Engine not started

Parameters, value

Outside temperature
The value indicates the outside temperature.
Measurement range: -128 °C to +127.75 °C

Passenger compartment temperature
The value indicates the passenger compartment temperature in the car.
Measurement range: -60 °C to +195 °C.

Control module power supply
The value indicates the power supply to the differential electronic module (DEM).
Measurement range: 0 - 24 V
Normal range: 12.0 - 14.5 V

CEM system voltage
The value indicates the voltage at the central electronic module (CEM).
The control module transmits the signal on the controller area network (CAN) and the differential electronic module (DEM) uses the signal to diagnose the power supply.
Measurement range: 5 - 30 V
Normal range: 12.0 - 14.5 V

Oil temperature
The value indicates the oil temperature in the Active on Demand Coupling.
Measurement range: -128 °C to +127 °C
Normal range: 50 - 60 °C.

Oil pressure
The value indicates the oil pressure in the Active on Demand Coupling.
Measurement range: 0 - 4 MPa
Normal range: 0.4 -2.0 Mpa.

Power supply solenoid
The value indicates the current through the control solenoid for four wheel drive.
Measurement range: 0 - 4095 mA.

Power supply pump motor
The value displays the current through the hydraulic feed pump.
Measurement range: 0 - 8191 mA.

Total mileage
The value indicates the total covered mileage of the vehicle.
Measurement range: 0 - 1048575 km.

Wheel speed
The value indicates the wheel speed.
The brake control module (BCM) transmits the vehicle speed signal on the controller area network (CAN) and the differential electronic module (DEM) uses the signal to activate four wheel drive.
Measurement range: 0-250 km/h.