FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

AW55-50/51SN Transmission






Cable key interlock, replacing

Removal

Preparations





S60R (B5254T4 engine)
Remove the center console. Center Console, Replacing.

S60 (other engines)
Remove the center console. (-2004) or (2005-).Center Console, Replacing.

V70R (B5254T4 engine)
Remove the center console. Center Console, Replacing.

V70 (other engines)
Remove the center console. (-2004) or (2005-).Center Console, Replacing.

V70XC/XC70
Remove the center console. (-2004) or (2005-).Center Console, Replacing.

S80
Remove the center console. See Center console, replacing Center Console, Replacing.
Applies to all models

Remove:
- the steering column covers
- the soundproofing panel on the left-hand side.

Removing the mechanical cable from the ignition switch




Move the gear shift lever to position P.
Turn the ignition key to position I or II.
Depress the lock button and pull the cable out of the ignition switch.

Removing mechanical cable from gear selector assembly




Detach the yellow locking sleeve slightly (use a screwdriver).

Note! The yellow locking sleeve must not be reused. A new locking sleeve must be used at installation.

Lift the cable from the gear selector assembly.

Removing the mechanical cable from the steering column




The cable is located in a clip on a bracket at the steering column and a clip in the climate control system.

Installation

Installing the mechanical cable





Note! Start installation from the ignition switch.

Route the cable down along the steering wheel bracket and under the climate control system.
Secure the cable in its clips at the bracket and climate control system.

Installing the mechanical cable on the mounting for the gear selector assembly




Route the cable along the gear selector cable to the gear selector assembly.
Connect the cable to the gear selector mounting.
If the guide sleeve on the key interlock wire breaks during removal/installation of the wire to the gear selector assembly, the guide sleeve must be replaced. Refer to: Guide sleeve key lock cable Guide Sleeve Key Lock Cable.
For connection to the lever adjustment see: Key interlock cable, initial setting and adjustment Procedures.

Initial setting of the key lock cable (adjusting)
Make the initial setting. See Key interlock cable, initial setting and adjustment Procedures.

Finishing work




Install the steering shaft covers.

S60R (B5254T4 engine)
Install the center console. Center Console, Replacing.

S60 (other engines)
Install the center console. (-2004) or (2005-). Center Console, Replacing.

V70R (B5254T4 engine)
Install the center console. Center Console, Replacing.

V70 (other engines)
Install the center console. (-2004) or (2005-). Center Console, Replacing.

V70XC/XC70
Install the center console. (-2004) or (2005-). Center Console, Replacing.

S80
Install the center console. See Center console, replacing Center Console, Replacing.
Install the soundproofing panel.