Input Speed Sensor/Output Speed Sensor, Replacing

Replacing the transmission input speed sensor and the transmission output speed sensor

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information is always correct.

Removal

Preparations
Switch off the ignition.

Removing the air cleaner (ACL) housing




The air cleaner housing ACL assembly with the intake pipe.

Removing the cable harness




Remove the mounting for the cable harness from the cover for the control system.
Unhook the mounting with the connectors for the cable harness from the bracket for the air cleaner (ACL) housing.
Remove the tie straps from the cable harness.
Separate the connectors for the transmission output speed sensor and the transmission input speed sensor.
Unhook the connectors from the mounting.
Clean thoroughly around the sensors.
Remove the sensors and the cable harness.

Installation

Installing the sensor




Install the new sensors.
Apply a little petroleum jelly to the O-rings for the sensors. Tighten to 5.5 Nm.
- Install the connectors for the sensors on the mounting. Assemble the connectors
- Install the tie straps for the cable harness
- Hook the mounting for the connectors on to the bracket for the air cleaner (ACL) housing
- Secure the cable harness mounting in the control system cover.

Installing the air cleaner (ACL) housing




Install the air cleaner housing (ACL) assembly with the intake pipe and connector.
Check and erase any diagnostic trouble codes (DTCs).