Acceleration Sensor Bodywork Rear (Four-C), Replacing

Acceleration sensor bodywork rear (Four-C), replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Location




The rear acceleration sensor is located behind the left-hand wheel arch in the cargo compartment, see the illustration.

Preparatory work




Ignition off.
Remove the hatch in the rear side panel on the left-hand side of the cargo compartment.

Removing the acceleration sensor
Remove the M8 screw.
Disconnect the connector.

Installation

Note! It is essential that the acceleration sensors are installed with the connector facing upwards and is secure in the vehicle. Otherwise movement may result in incorrect values being returned to the system, with poorer driving characteristics, when cornering for example, as a result.

Note! For tightening torques, see Specifications [1][2]Specifications.

Installing the acceleration sensor
Install the M8 screw.
Connect the connector.

Finishing work
Install the hatch in the side panel.
Test the function.