Switch Electrical Sun Blind and Heater Pad, Replacing

Switch electrical sun blind and heater pad, replacing

Removal


Removing the panel for the 12volt socket





Remove:
- the cover over the 12 volt socket on the rear edge of the center console. Insert a weatherstrip knife in the lower edge and pry off
- the 2 screws and the panel for the 12 volt socket.

Removing the switch




Disconnect the connector from the switch.
Press in both the catches on the switch. Press the switch out through the panel.

Installation

Installing the switch




Position the switch.
Connect the connector to the switch.


Installing the panel for the 12volt socket





Install:
- the panel for the 12 volt socket and the 2 screws. Tighten
- the cover over the 12 volt socket on the rear edge of the center console.