Ride Height Sensor: Service and Repair

Position sensor suspension rear (Four-C), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Ignition off




Ignition off.
Raise the vehicle.

Removal

Removing the position sensor





Remove:
- the nut for the linkage
- the position sensor. Press in the catch hook and angle the bracket downwards
- the connector
- the bracket from the position sensor
- the 2 screws.

Installation

Installing the position sensor

Install:
- the position sensor on the bracket
- the 2 screws
- the connector
- the linkage
- the nut.
Align the bracket which the position sensor is on. Press into position.

Finishing

Calibrating the position sensor
The position sensor must be calibrated after replacement.