Checking Local Lighting

Checking local lighting

Checking the connectors








- Ignition off
- Check the power door mirror connector. Check for contact resistance and oxidation.
In particular, check for any damage
- Ignition on.

Other information:
- To access the power door mirror connector, see Outside temperature sensor door mirror, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals





Is the lamp in the power door mirror working?

Yes - FAULT FOUND

No - Checking the components and wiring

-------------------------------------------------

Checking the components and wiring
Check the cable between door control module terminal #10B and power door mirror terminal #6. Check for an open-circuit. Check for a short-circuit to supply voltage.
Check the cable between door control module terminal #8B and power door mirror terminal #13 for an open-circuit.
Remedy as necessary.

Other information:
- Signal specification Signal Specification, Driver Door Module (DDM) / Passenger Door Module (PDM)
- Connecting the breakout box Connecting the Breakout Box
- To access the power door mirror connector, see Outside temperature sensor door mirror, replacing Service and Repair
- Bulb ground lighting door mirror, replacing Bulb Ground Lighting Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals





Continue - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check if the lamp in the power door mirror lights.





Is the bulb in the power door mirror working?

Yes - Verification complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the connectors

-------------------------------------------------